For some cells, rectification was incomplete, as seen by the shal

For some cells, rectification was incomplete, as seen by the shallow, but nonzero slope of the obtained nonlinearities for nonpreferred signals (Figure 3B). Iso-rate curves (Figures 3A–3C, blue lines) displayed more variable shapes than iso-latency curves. Rucaparib order For some cells, the iso-rate curve had approximately the same shape as the cell’s

iso-latency curve (Figures 3A and 3B), also indicating a nonlinearity of stimulus integration that is approximately threshold-quadratic or sometimes close to threshold-linear (insets in Figures 3A and 3B, blue lines). For other ganglion cells, however, the iso-rate curves displayed a notably different shape (Figure 3C), characterized by a notch along the lower-left diagonal. This notch gave the curves a distinctive nonconvex shape. It showed that relatively little contrast was required for these cells to achieve the predefined spike count when both receptive field halves were stimulated with similar (negative) contrast. Stimulation

of only one receptive field half, on the other hand, required much larger contrast values. Thus, when considering the spike count, these ganglion cells displayed exceptional sensitivity to spatially homogeneous stimulation of the receptive field, and in the following we will therefore refer to these cells as homogeneity detectors. The classification of iso-rate curves into convex and nonconvex curves did not depend on the chosen target spike count. Convex iso-rate curves appeared to be largely scaled versions of each selleck kinase inhibitor other if measured for the same cell at different spike counts (Figure 3D), whereas iso-rate curves of homogeneity detectors displayed the characteristic

nonconvex shape over a range of different spike counts (Figure 3E). However, the notch in the iso-rate curve became more pronounced with higher target spike counts, a fact PDK4 to which we will return when discussing the underlying mechanisms. In addition, the nonconvex shape of homogeneity detectors did not depend on the exact stimulus layout; it proved robust to changes in stimulation radius or insertion of a gap between the two stimulus areas (Figure 3F). To quantify the degree to which individual iso-response curves were convex or nonconvex, we defined a form factor that compares the radial distance of the curve along the lower-left diagonal to its linear prediction obtained from the intersections of the curve with the two axes of the plot (see Experimental Procedures for details). In particular, this form factor is smaller than unity for a nonconvex iso-rate curve as in Figure 3C and larger than unity for the iso-response curves of Figures 3A and 3B. Calculating the form factor for all measured iso-response curves confirmed that iso-latency curves always had similar convex shapes (Figure 3G). In fact, their form factors clustered around their average value of 1.38 (standard deviation: 0.08), close to the value of 2≈1.41, which is expected from quadratic integration of preferred stimuli.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>